IBM 000-J01 System HAC Implementation Technical Skill Test

IBM 000-J01 System HAC Implementation Technical Skill Test, Attend this IBM 000-J01 System HAC Implementation Technical Skill Test will get a Good Score 80% on Main Exam.

Sample Questions

Q) A non-clustered system IASP had given it, but the only ASP has been erased. The system has been added to the cluster, as well as the need to connect the device to the domain for switching ASP. Which of the following must be met in order to successfully add a node to a domain device?

a) ADDDEVDMNE team; IPL system; Then follow ADDDEVDMNE command again.

b) Output node and restart.

c) Add a node in the restoration for the corresponding device CRG.

d) Follow ADDDEVDMNE team.

e) None

Q) When the partition condition is detected, the best approach is the following:

a) Do not take any action; Clustering will recover on their own without failover.

b) Do not take any action; Clustering will automatically switch to the backup node

c) Determine the cause of the state of the sections and manually initiate the recovery.

d) IPL partitione node.

e) None

Q) Normal use of peer-CRG in the cluster:

a) In order to determine the components in the administrative area.

b) In order to determine the location of the cluster administrative tasks.

c) In order to determine the primary and multiple backup nodes to replicate user profiles.

d) In order to collect the CRG in the cluster to coordinate switching operations.

e) None

Q) If the inactive node will not start, it should be done?

a) Use CHGCLUNODE, to change the status to failure, and run the command again STRCLUNOD.

b) Check the IP-address, * Inetd and ALWADDCLU network attribute in the system will not.

c) Check the IP-address, * Inetd ALWADDCLU and network attributes of the system to run the command.

d) Remove node from the cluster, add the node back to the cluster, and try again team STRCLUNOD.

e) None